We continue to wait for the end of the 24hr pressure stabilization period which ends at 8:00pm edt tonight (10/27). After that, we will begin to configure for Hot Thermal Balance.
Due to the issue with the SAS gimbal heating, we are going to power off the SAS gimbal actuators to allow for additional power through the gimbals.
We have decided to defer running the Command Barker Test at this time. We may decide to run it during thermal cycle or after thermal vac. This test is not dependent on temperature, but just taking advantage of idle time.
This blog follows the progress of the LRO mission through Integration and Testing at NASA's Goddard Space Flight Center and launch site processing at KSC\Astrotech. Its purpose is to enable communication to the entire LRO Team about the status of ongoing activities.
LRO was launched June 18th, 2009 at 5:32pm EDT from KSC. This BLOG will follow the progress of the mission as LRO travels to the Moon and establishes orbit around it.
This BLOG will be periodically updated during LRO's early mission but as the nominal mission unfolds the official NASA LRO website and the LRO Science Instrument's own websites will evolve into a more interesting sources of LRO science results as postings appear there first and LRO engineering and operations (source of this site) will become increasingly routine.
LRO was launched June 18th, 2009 at 5:32pm EDT from KSC. This BLOG will follow the progress of the mission as LRO travels to the Moon and establishes orbit around it.
This BLOG will be periodically updated during LRO's early mission but as the nominal mission unfolds the official NASA LRO website and the LRO Science Instrument's own websites will evolve into a more interesting sources of LRO science results as postings appear there first and LRO engineering and operations (source of this site) will become increasingly routine.
Monday, October 27, 2008
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment